Bienvenu(e)! Identification


bon en fait ... il ne faut pas utiliser 255.255.255.255/255.255.255.255 pour ALL mais 0.0.0.0/0.0.0.0

https://supportforums.cisco.com/discussion/11168086/linksys-rv016-and-two-wans-cabledsl

On the RV082:

System Management-> Dual-WAN
Change to Load Balance (Auto Mode) At the bottom of the page you will now see Protocol Binding
Select HTTPS [TCP/443~443] from the dropdown
Select the source IP or IP range: (i.e. 192.168.1.100 to 150) This will bind HTTPS for any LAN device that uses an IP in this range.
Select the Destination IP: Usually leave at 0.0.0.0 to 0.0.0.0 for ALL destinations
Select the Interface to bind the protocol to (WAN1 or WAN2)
Check the Enable box and Add to list. Save Settings at bottom of page.
Seuls les utilisateurs enregistrés peuvent poster des messages dans ce forum.

Cliquez ici pour vous connecter